WATER TANK ACCESSORIES
Standard Accessories below. Accessories can be customized based on customer' requirements and end use. Design needs may require different standards and specific equipment.
Manway entry/access ports
Drain & Fill Hoses
Our fill and drain fittings are one piece molded to eliminate leak paths. Fill / Discharge are available in industry standards of 2”, 4” and 6”. Drain fittings are available in 2”, 4”, 2” dome, or blind flanges. Fitting locations can be customer specific, but are usually on opposite corners or down the center line of the tank.
2”, 4” and 6” inch Gate Valves and Ball Valves are available.
Manway Access Ports
Manway access ports are available on both styles of tanks. They are recommended on water tanks that will be reused to ease preparation for storage.
Please note that it is not recommended to enter any fuel tank
without recommended respiratory and personal safety equipment.
Bonded handles are available in two styles with pull strength and pricing in mind
Ground Sheets are recommended to help protect your tank from foreign object and extend the life of your tank.
Bern Liners are simple and economic solutions for secondary containment systems in the event of tank failures. Highly recommended for fuel tanks and any water tanks with contaminated water.
Our repair kits include 3 sizes of wooden plugs for temporary repairs, 3 sizes of Clam Clamps for permanent repairs, and a knife to ease installation.
A vent pipe is included with each tank. Options include a mushroom vent, double outlet vent, and (for fuel) a pressure relief vent. Flame arrestors are included for fuel tanks.
Hoses are available in 2”, 4” and 6” diameter. Hoses are typically 10’, 12’, or 20’ in length.
All elbows are 90 degrees and available in 2”, 4” and 6” to assist in connecting fill and drain hoses.
1 601 889 9050 | firstname.lastname@example.org | www.avon-aef.com
MILITARY | COMMERCIAL
Disclaimer | © 2014 Avon Engineered Fabrications. All Rights Reserved